The analog output module series RAGxxxx with bar indicator serve as control modules with manual override function for the control of 1 to 2 analog drives. There is a rotary switch for each drive with "Auto"-"Close"-"Open"-"Pot". There is an extra layer for the "Auto"-Position, in order to indicate manual override to the DDC. In Order to get this indication in the porsitions "Off", "Open" and "Pot" you have to put an"-H0" at the end of the typ-Code (e.g. RAG5025-H0). At the position "Close" you will get 0V and at the position "Open" you will get 10V at the output. In the position "Pot" you can manually adjust the output voltage by the means of the potentiometer. The voltage of each output is shown by the intensity of green LEDs. You can choose between 0-10V, 10-0V, 2-10V or 10-2V for every single channel by the means of jumper. There is an extra clamp 43 were you can get constant 10V. You can load each output up to 10mA. RAG5015 - 1 analog output RAG5025 - 2 analog outputs
Datasheets description technical description data sheet |